ABS air conditioner panel fouling Anti-fingerprint UV coating, air conditioner panel surface hydrophobic oleophobic coating abrasion treatment. The product is widely used in Japan, cell phones, cameras, DV camcorders, high-quality digital products metal casing coating. Antifouling slip tile bathroom and ceramic products as well as stainless steel surface protection coating. Application materials: metal materials: including high-quality stainless steel, hard aluminum, aluminum alloy plate, brushed aluminum, magnesium alloy plate, chrome, titanium metal and other hard materials attached. Ceramics, stone, plastic, wood and other materials. Also with a variety of primer or topcoat paint as illumination. (UV paint, PU paint, fluorocarbon, metallic paint, enamel, etc.) Basic Properties Appearance colorless to pale yellow liquid Viscosity (25 ℃) 8.4mPa;? S solid component of 27% or more ethanol or no diluent IPA water coating thickness 2 ~ 5μm transparency and good light transmission (full-spectrum light transmittance of 90% or more) PH 7 ~ 8 hardness 8H above (Mitsubishi Pencil hardness test special hardness) Properties: film hardness up to more than 8H, wear anti-scratch superior performance; good adhesion, thin film formation, transparency, specular high gloss shiny plump, comfortable, good antibacterial and antifungal effect, anti-fingerprint antifouling effect, easy adhesion fingerprints and other dirt material, clean easy care, durable Foul greatly improve product quality; rust-proof, non-slip, water oil penetration, acid salt corrosion resistance, high temperature resistance, UV resistance, aging properties are very superior insulation durable, bright as new, metallic fine, noble quality; is ideal for advanced functional coatings products. Nontoxic, green and healthy, do not pollute the environment for waste recycling, no secondary costs. Formaldehyde emission: 7 days painting 0.07mg / L, in line with the Food Sanitation Law and food / additive requirements. Theory of use: 8 ~ 10g / m coating thickness: 2um over Thinner: ethanol or isopropanol dilution: painting equipment according to needs, the recommended maximum of 3 times. Painting by: no special requirements with the general paint, the choice of spraying, dipping, flow coating, roller coating and brush wipes and so on.